All rights reserved. UL Compliant Additionally, DoorKing, Inc. This manual is copyrighted, all rights reserved.
|Published (Last):||14 January 2019|
|PDF File Size:||14.84 Mb|
|ePub File Size:||15.66 Mb|
|Price:||Free* [*Free Regsitration Required]|
Phone: Fax: www. All rights reserved. Page 3 Use this manual with the following model only. Model with circuit board DoorKing, Inc. These systems can produce high levels of force; therefore it is important that you are aware of possible hazards associated with your gate operating system. These hazards may include pinch points, entrapment, absence of controlled pedestrian access or traffic backup. Never let children operate or play with gate controls.
Keep the remote control away from children. Always keep people and objects away from gate. This system will sense an obstruction in both the opening and closing gate cycles, and will cause the gate to reverse direction should an obstruction be encountered. If the system detects a second obstruction before reaching the full open or close limit after the initial reversal, an alarm will activate and the operator will require a reset before resuming normal operation.
This will help insure that your installation is performed in an efficient and professional manner. The proper installation of the vehicular slide gate operator is an extremely important and integral part of the overall access control system. Page Mounting Positions 1. Once the mounting position has been determined, the chain idlers must be adjusted to accommodate the mounting position chosen before the operator is mounted to the pad or post.
The idlers are factory set for the front, pad mount position. Page Mounting Options 1. If the operator is to be center mounted, the post mounting method must be used. Page Post Mounted Operators 1.
Page Operator Installation 1. Page Chain Installation 1. Secure the chain brackets to each end of the gate so that the brackets are level with the top chain knockouts in the operator housing. Brackets should be attached to the inside of the frame so that the chain bolts, when attached, do not protrude beyond the frame of the gate figure Page Front - Post Mount 1.
Secure the chain brackets to each end of the gate so that the brackets are level with the bottom chain idlers in the operator housing.
Brackets should be attached to the inside of the frame so that the chain bolts, when attached, do not protrude beyond the frame of the gate. Note that the chain is routed between the fence and the gate in this type of installation.
Page Center - Post Mount 1. Note that the gate travels between the fence and the chain in this type of installation. Page Warning Sign Installation 1. The purpose of the warning signs is to alert uniformed persons, and to remind persons familiar with the system, that a potential hazard may exist so that appropriate action can be taken to avoid the hazard or to reduce exposure to the hazard.
Permanent wiring must be installed to the operator as required by local electrical codes. It is recommended that such work be performed by a licensed electrical contractor.
Doorking 9150-380 Manuals
9150 Commercial and Industrial